Supermicro X10SLH-LN6TF User Manual page 89

Port 0 ~ Port 5 Hot Plug
This feature designates the port specified as hot pluggable. Set this item to
Enabled to enable hot-plugging. The options are Disabled and Enabled.
Port 0 ~ Port 5 SATA Device Type
This feature configures the selected SATA port to support either a solid state
drive or hard disk drive. The options are Hard Disk Drive and Solid Sate Drive.
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization sequence to the device. The options are Disabled and Enabled.
If IDE is selected in SATA Mode Selection above, the following items are
displayed:
Serial ATA Port 0~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
If RAID is selected in SATA Mode Selection above, the following items are
displayed:
Serial ATA Port 0~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0 ~ Port 5 Hot Plug
This feature designates this port as hot pluggable. Set this item to Enabled to
enable hot-plugging. The options are Hard Disk Drive and Solid State Drive.
Port 0 ~ Port 5 SATA Device Type
This feature configures the selected SATA port to support either a solid state
drive or hard disk drive. Set this item to Enabled to enable hot-plugging. The
options are Enabled and Disabled.
4-17
Chapter 4: AMI BIOS