Battery Removal And Installation; Battery Removal - Supermicro X10SLH-LN6TF User Manual

Important: The SPI BIOS chip installed on this motherboard is not re-
movable. To repair or replace a damaged BIOS chip, please send your
motherboard to RMA at Supermicro for service.
Question: I think my BIOS is corrupted. How can I recover my BIOS?
Answer: Please see Appendix C - BIOS Recovery for detailed instructions.
Question: Why do I get an error message "IASTOR.SYS read error" and "press F6
to install Intel RAID driver" when installing Windows on my motherboard?
Answer: To solve this issue, disable the IPMI jumper. Another solution is to use a
USB floppy drive instead of the onboard floppy drive. For the IPMI jumper location,
please check Chapter 1.
Question: What is the heatsink part number for my X10SLH-LN6TF motherboard?
Answer: For the 1U passive heatsink, ask for SNK-P0046P (back plate is included).
For the 2U active heatsink, use SNK-P0046A4.
Question: Why can't I recover the BIOS even when I've followed the instructions
in the user's manual for the motherboard?
Answer: Please disable the IPMI jumper and try it again. For the jumper location,
please check Chapter 1.
3-4

Battery Removal and Installation

Battery Removal

To remove the onboard battery, follow the steps below:
1. Power off your system and unplug your power cable.
2. Locate the onboard battery as shown below.
3. Using a tool such as a pen or a small screwdriver, push the battery lock out-
wards to unlock it. Once unlocked, the battery will pop out from the holder.
4. Remove the battery.
Chapter 3: Troubleshooting
3-5