External Dimensions And Each Part Name - Mitsubishi FX2N User Manual

FX2N-32DP-IF Profibus-DP Interface Unit
1.2

External Dimensions and Each Part Name

Dimensions: mm (inches)
Accessory: GSD files (FD: 1 piece)
Figure 1.1: External Dimensions
a) Connector for Profibus cable (D-SUB 9 pin)
b) Power supply terminals (screws terminal: M3.5 (0.14"))
c) Direct mounting hole (2- 4.5 (0.18"))
d) 24 V DC power terminal (screws terminal: M3.5 (0.14"))
e) RUN/STOP switch: When this switch is in the RUN position, the 32DP-IF will exchange
f) Communication port for FX-20P-E and personal computer
g) POWER LED : ON when AC power is supplied.
h) RUN LED
i) BF LED
j) DIA LED
k) Hook for mounting DIN rail
l) DIP switches for slave address of this unit
m) Connector for extension cable
n) Groove for mounting DIN rail (DIN rail width: 35 mm (1.38"))
Weight: Approx. 0.4 kg (0.88 lbs)
data with extension units/blocks and special function blocks. If this
switch is in the STOP position, the 32DP-IF will exchange only input
data with extension units/blocks.
: ON when 32DP-IF is exchanging data with extension units/blocks and
special function blocks.
: ON when a communication error is detected (No data exchange).
: ON when notice of diagnostic data is detected.
Introduction 1
1-2