Adjusting The Depth Of The Accessory Tray; Adjusting The Brake Effect; User Brake - Adjustment; Drum Brake - Adjustments - Invacare Dahlia 30 Service Manual

Loosen the 2 screws B on the accessory tray A.
1.
2. Adjust to the desired depth.
3. Re-tighten the screws again.
Tools: 5 mm Allen key
3.19 Adjusting the depth of the accessory
tray
1.
A
Loosen the screws B and the nuts C and remove the main
plate A.
Tools: 5 mm allen key, 13 mm spanner
2.
A
Turn the main plate A 180º.
A
Re-mount the turned main plate A and re-tighten the screws
B and nuts C.
In this position, the anti-tip device can not be folded.

3.20 Adjusting the brake effect

3.20.1 User brake — adjustment
To attain the correct braking effect, the brake pin should press into
the tire when you apply the brake. The brake may therefore require
depth adjustment.
1572308-B
B
1.
2.
3.
C
3.20.2 Drum brake — adjustments
1.
2.
C
WARNING!
Risk of reduced brake effect
– Incorrect setting or use of the brake reduces the
braking effect.
C
Tool: 5 mm Allen key
Loosen the screw A.
Move the brake attachment to the required position.
Re-tighten the screw A.
There should be a distance of approximately 6 mm between
the pin B and the tire C.
CAUTION!
Risk of trapping fingers
– Be careful not to trap your fingers between the brake
pin B and rear wheel.
Adjust the brake effect with the adjustment nut A on the wire.
When the desired brake effect is achieved, fixate the brake wire
with the fixation nut B.
Settings and Adjustments
A
B
A
25