Mounting The Seat Plate Extension; Seat Plate Extension To The Front; Seat Plate Extension To The Rear; Seat Plate Extension Sidewise - Invacare Dahlia 30 Service Manual

Dahlia®30 / 45
WARNING!
Risk of tipping
– Make sure that the castor attachments are mounted,
correctly, the castors must be placed on the outside
of the frame. If the castor attachments are turned,
they must be mounted on the opposite side, with the
castors facing outwards.

3.12 Mounting the seat plate extension

The seat plate extension kit can be used in order to increase the
width and depth of the seat plate according to the need of the user.
B
The seat plate extension kit consists of two extension plates A and
screws, washers and nuts B to fixate the extension plates.
The following section will show some examples of how the seat plate
extension kit can be used.
The seat 2 seat plate extensions can be combined in many
ways in order to give extra width / depth depending on the
need of the user.

3.12.1 Seat plate extension to the front

D
A
C
B
1. Remove the seat cushion.
Place the extension plates A on the front of the seat plate D.
2.
The extension plate can be adjusted 25 mm or 50 mm
forward.
Attach the screws C on the upper side of the seat plate. Attach
3.
the washers and nuts B under the seat plate to fixate the
extension kit.
4. Tighten the screws.

3.12.2 Seat plate extension to the rear

1. Remove the seat cushion.
Place the extension plates A at the back of the seat plate D.
2.
The extension plate can be adjusted 25 mm, 50 mm or
75 mm rearward.
22
A
C
C
A
Attach the screws C on the upper side of the seat plate. Attach
3.
the washers and nuts B under the seat plate to fixate the
extension kit.
4. Tighten the screws.

3.12.3 Seat plate extension sidewise

1. Remove the seat cushion.
Place the extension plates A on both sides of the seat plate D.
2.
The extension plate can be adjusted 25 mm or 50 mm
sidewise.
Attach the screws C on the upper side of the seat plate. Attach
3.
the washers and nuts B under the seat plate to fixate the
extension kit.
4. Tighten the screws.
In order to use the extension kit in this position, the width
of the armrests also needs to be increased.
See section: "Width adjustment seat" for instruction on how to
change the armrest width.

3.13 Width adjustment

1.
Loosen the 4 screws A.
2.
Adjust the attachment bars B in order to fit the table to the
desired width. Re-tighten the screws.
3.
Fit the table to fit the width of the chair C.
A
A
1572308-B