Repositioning The Backrest Joint; Mounting The Legrest Attachment For High Position; Mounting The Accessory Tray - Invacare Dahlia 30 Service Manual

Dahlia®30 / 45

2.11 Repositioning the backrest joint

The width extension spacers can be used when there is need
for a wider backrest bar. The spacers will add an extra 25
mm space on each side.
A
1. Loosen the three screws A on the outside of the seat frame.
Tools: 5 mm allen key
Insert the plastic spacers B between the backrest attachment
2.
C and the seat frame.
Retighten the three screws A (10 Nm).
3.
4. Repeat the procedure on the opposite side.
2.12 Mounting the legrest attachment for
high position
With the high position legrest attachment, the fixation of the
legrest will be 5 cm higher.
The high position legrest attachment is recommended for
users with a height of 185 cm and taller.
1.
A
B
Remove the upper screw A and the lower screw and washer B.
Remove the ordinary legrest attachment C.
Tools: Screwdriver (PH 2) for screw A, allen key 5 mm for
screw B.
2.
A
Mount the high legrest attachment D in the seat frame. Re-insert
the upper screw A and the lower screw and washer B.
Re-tighten the screws.
Tools: Screwdriver (PH 2) for screw A, allen key 5 mm for
screw B.
10
B
C
C

2.13 Mounting the accessory tray

1.
A
Loosen the screws B of the accessory tray A and adjust the
width.
2.
A
Mount the accessory tray A on the chassis, the hooks C should
be placed on the frame.
3.
Secure the accessory tray with the attachment straps D. Thread
the straps through the slot E and wrap them around the hooks.
Secure the attachment straps firmly.
4.
Re-tighten the screws B to fixate the width.
The accessory tray will be instable
– Always secure the tray with all four attachment straps.
B
C
1572308-B