Dahlia®30 / 45
8.
Mount the push bar M and tighten the knob L.
9.
Re-mount the safety shackle C and attach the gas piston.
WARNING!
Safety risk
The wheelchair may collapse
– Remember to always reinsert and fasten the safety pin
when it has been removed.
2.2 Placing the wires
2.2.1 Wires with backrest plate
B
A
6
Thread the wires on the outside of the backrest tubes B.
1.
Place the wires in the holders/clips A in order to hold them in
2.
place.
Fold the slack of the wires under the seat to get them
out of the way.
2.2.2 Wires with tension adjustable backrest
B
1.
Place the wires A and B as shown on the picture above.
Risk of damage to the wires
– It is important that the cable for the assistant brake
A is placed on the inside of the backrest tubes.
2.
Place the wire for the backrest/seat recline B outside of the
backrest tubes.
3.
Place both of the wires on the inside of the backrest attachment
C.
Attach the wires to the backrest tubes E with the straps D.
4.
Fold the slack of the wires under the seat to get them
out of the way.
CAUTION!
Risk of reduced brake effect
– The wires must not be crossed on the backrest!
A
C
E
C
D
1572308-B