Power Up The Wilson Electronics Sleek - Wilson Electronics SLEEK 2B5225 Installation Manual

RF Safety Warning: The Outside Antenna must be either a Wilson Electronics Magnet-Mount or
Mini-Magnet Mount antenna and requires at least an 8 inch separation distance from all persons.
Other O utside A ntennas m ay b e u sed w ith fi x ed b uilding i nstallations p rovided t hat ( a) t hey a re
located with at least a 30 inch separation distance from all persons, (b) their gain less cable loss
does not exceed 15 dBi, and (c) they are not operating in conjunction with any other antenna or
Signal Booster.
2. Attach the Mounting Bracket
A mounting bracket is provided for attaching the Sleek to your vehicle's dash. Other options are also
available from Wilson Electronics.
3. Attach the Sleek to the Bracket
®
Once you have installed the bracket in the desired location, and waited 24 hours for adhe-
sive to cure, attach the Sleek by aligning the rectangular hole on its back with the tab on
the mount bracket, grasping the sides of the Sleek, and sliding it downward approximately
¼ inch into place.
Once the cradle is attached, you can adjust the angle of the adhesive bracket by applying
gentle pressure to the top or bottom of the Sleek. The bracket is designed to swivel when
the knurled nut is loosened for greater adjustability of the Sleek viewing angle. To lock
bracket into position, tighten large nut.
4. Attach the Outside Antenna cable to the Sleek
Attach the cable from the Outside Antenna to the antenna connector
on the Sleek. (See Figure 1)

Power up the Wilson Electronics Sleek

Accessory port to power your phone, some adapters available
through Wilson Electronics at 866-294-1660. (See Figure 2)
Connect the mini-USB plug on the power cable to the Sleek's mini
USB port located on the bottom of the Sleek and insert the adapter
into the vehicle power adapter of your vehicle. The Sleek may remain
on all the time. However, leaving the Sleek on in a vehicle when it is
not running can discharge the battery in a day or two.
Note: The 12V DC power source on many vehicles is shut off
with the ignition key.
Warning: Use only the supplied Wilson Electronics power
supply.
Warning: Make sure the Outside Antenna cable is
connected before powering up the Sleek.
3
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
ADHESIVE BRACKET- Included in this package
1. Clean the area where the bracket is to be mounted with the
supplied alcohol wipe. Allow to dry.
2. Peel the backing to expose the adhesive and press the
bracket onto the desired location in the vehicle. Note: Be sure
the tab is positioned vertically, not horizontally.
3. Allow the adhesive to cure for 24 hours before you attach
the Sleek.
®
®
Mon.- Fri. Hours: 7 am to 6 pm MST.
Antenna
connection
Figure 1
Sleek Power port. Connect the
Wilson Electronics's power supply
Figure 2
Accessory USB Power port