How It Works; Vehicle Installation Diagram; Install The Outside Antenna - Wilson Electronics SLEEK 2B5225 Installation Manual

General
Your W ilson E lectronics S leek h as b een c arefully e ngineered t o s ignifi c antly i mprove t he p erformance
of your phone. Together with an Outside Antenna, the Sleek's state-of-the-art circuitry is designed to
increase your phone's signal to and from the cell tower. The Sleek reduces disconnects and dropouts
and increases data communication rates on 2G, 3G networks and 4G networks (in some models).

How it Works

With the phone in the cradle and while using a wireless Bluetooth headset (or hands free device) the
Outside Antenna collects the cell tower signal and sends it through the cable to the Sleek. The signal
is then boosted by the Sleek and sent to the phone. When the phone transmits, the signal is picked up
wirelessly and boosted by the Sleek and transmitted back to the cell tower through the Outside Antenna.
NOTE: The cell phone must be placed in the cradle to work properly.

Vehicle Installation Diagram

Outside Antenna
communicates with cell
Warning: DO NOT use phone covers that have chrome or any other metallic surface. It may block
cellular signals
Vehicle Installation

1. Install the Outside Antenna

To receive the best cell signal, select a location for the Outside Antenna that is preferably in the center
of the vehicle's roof, 12 inches away from any other antennas, free of obstructions, and at least 6 inches
from the rear or side windows or sunroof.
Mini-Magnet
Mount Antenna
Shown
The Outside Antenna must be installed vertically.
Antenna performance will be degraded if the
antenna is not vertical.
The antenna cable is small yet strong enough that it
may be shut in most vehicle doors without damaging
the cable.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
tower
Sleek w/phone
Carefully
Pull Down
Door Seal
For a more professional looking installation, run the
antenna cable under the door seal. Carefully pull
down the door seal. Run the cable under the seal
and push the seal back into place. This prevents
constant wear and tear on the cable as the door
opens and closes. The antenna cable is small
enough to easily tuck under the door seal or
plastic molding.
Mon.- Fri. Hours: 7 am to 6 pm MST.
Sleek w/phone
Sleek boosts
signal to and
from cell tower
Run Cable
Under Seal
2