Maintenance; Periodic Inspection Table - CanyCom BP416 Operator's Manual

7. Maintenance

7.1 Periodic Inspection Table

Failure to carry out inspection and maintenance properly will cause machine failure.
Refer to the following table for inspection procedures and frequency.
Some inspection and maintenance procedures in the table
below require technical knowledge or specific tools and mea-
suring instruments. If you have difficulty performing these pro-
cedures, or do not have the correct tools or instruments,
contact your dealer or a Canycom service center.
Item
Ease of
starting
Condition
of rotation
Exhaust
gas
condition
Air cleaner
Tightening
Valve
clearance
Maintenance
Content of inspection
Investigate starting condition of
engine and check for abnormal
noise.
Check if glow plug works prop-
ery.
Check speed at low idling and at
high idling.
Check that rotation is smooth.
Check for catching of accelerator
lever when accelerating engine,
engine stall, or knocking.
Warm up engine thoroughly, then
check for abnormal exhaust gas
color or exhaust sound, low idling to
high idling.
Check for gas leakage from exhaust
pipe or muffler.
Check for cracks, deformation of
case, looseness of cover or
connecting piping.
Check for dirty or damaged element.
Check for looseness of nuts and
bolts at tightening portion of
cylinder head and manifold
*If no leakage of gas or water is
found from these portions, this
check can be omitted.
Check the valve clearance
* When noise due to abnormal valve
clearance is absent and the engine is
running smoothly, this inspection may
be omitted.
NOTICE
Check that engine starts
smoothly and makes no
abnormal noises.
Must work properly.
Must be at specified speed.
Must rotate smoothly.
There must be no catching,
stalling of engine,
or knocking.
Exhaust gas color and
exhaust sound must be
normal.
There must be no gas
leakage.
There must be no cracks,
deformation of case,
looseness of cover or
connecting piping.
There must be no noticeable
dirt or damage.
If gas or water leaks have
been found, check cylinder
head and manifold retain-
ing nuts and bolts for
looseness.
The valve clearance must be
normal.
– 20 –
Inspection Inspection
interval interval
Remarks
Please contact your
Canycom distributor
for inspection
Cleaning/replacement:
See page 29 & 37
Please contact your
Canycom distributor
for inspection