Belt Stopper; Maintenance After Use - CanyCom BP416 Operator's Manual

Belt stopper

V-belt
3560M-0707-090

7.8 Maintenance After Use

Maintenance After Use in Normal Conditions
・ After using the machine, remove any mud, water, or other foreign matter stuck to the machine.
Do not wash the engine or control panel with water. This will allow water to enter and lead to rust.
・ When leaving the machine outdoors, cover it with a waterproof cover.
Maintenance After Use in Cold Weather
・ After using the machine, remove any mud, water, or other foreign matter stuck to the machine.
Then park the machine on concrete or firm dry ground, or set it on blocks. If water or mud stuck
to the machine freezes, it may cause failure.(In extremely cold areas, put wooden blocks under
the crawlers at right angles to the machine.)
・ When leaving the machine outdoors, cover it with a waterproof cover.
If the machine freezes and it is impossible to operate, do not try to move it by force.
Use warm or hot water to melt the frozen parts or wait for the ice to melt.
Be careful when moving the machine.
If the machine is moved by force, Canycom does not take responsibility for damage
or failure.
Maintenance
Engine pulley
Belt stopper
Transmission pulley
Belt stopper
7.7.6
Belt stopper
・ If the drive clutch is not disengaged completely,
the belt stopper may be maladjusted. When the
belt stopper is removed for the replacement of
the belt, adjust it as follows.
・Stop the engine during the adjustment.
1. Remove the safety cover .
2. With the drive clutch lever positioned at "RUN", set
the clearance (J) between the traveling V-belt and
the belt stopper to about 5 to 6 mm, and the clear-
ance (K) to about 10 to 20 mm. (With the drive
clutch lever positioned in "RUN", assure a clearance
of 5 mm or more between the belt stopper and the
other belt. )
3. Set the belt stopper on the transmission pulley side
so that the clearance of it from the belt is uni-
formized all around the periphery of it.
NOTICE
– 35 –
NOTICE