Power Package Fluid (Fluid For Hydraulic Dump) - CanyCom BP416 Operator's Manual

3560M-0704-040
3560M-0704-050
Maintenance
7.4.3 Hydraulic Pump Power Package Fluid
Inspection/Adding
1. Remove the fluid filler cap.
2. Visually inspect the oil level. If oil is short, remove
Fluid filler cap
3. Replace the fluid filler cap.
4. Start the engine to circulate the fluid
Changing
1. Prepare a suitable container to catch the drained fluid.
Oil tank
2. Remove the oil tank mounting bolts, dismount the oil
3. Replace the oil tank.
4. Open the fluid filler cap, and pour in the fluid.
– 27 –
NOTICE
Low fluid levels may decrease dump perfor-
mance. Check the fluid level every 100
hours.
the oil filler cap and replenish oil.
Fluid to use: See page 24.
NOTICE
When the engine is first started and the bed
of the truck is raised after adding fluid, knock-
ing may occur due to entrapped air. To elimi-
nate knocking, repeat above steps 2 to 3
times.
tank, and drain oil.
NOTICE
Dispose of the drained fluid properly.
(See item "Inspection/Adding Fluid" above.)