Electrical Safety - Husqvarna PG820 RC Operator's Manual

WARNING! Never allow children to use or
!
be in the vicinity of the machine.
WARNING! Overexposure to vibration
!
can lead to circulatory damage or nerve
damage in people who have impaired
circulation. Contact your doctor if you
experience symptoms of overexposure
to vibration. Such symptoms include
numbness, loss of feeling, tingling,
pricking, pain, loss of strength, changes
in skin colour or condition. These
symptoms normally appear in the
fingers, hands or wrists. These
symptoms may be increased in cold
temperatures.
Work area safety
The machine's risk area
• When starting the machine nobody is permitted to be
within the area shown in the following illustration.
Then, the operator should take great care in the risk
area during the machine operation.
• Observe your surroundings to ensure that nothing can
affect your control of the machine.
• The machine can be remote controlled over long
distances. Do not operate the machine unless you
have clear supervision of the machine and its risk
area. Cordon off the work area or a restricted area for
the public.
• Do not use the machine in bad weather, such as
dense fog, rain, strong wind, intense cold, etc.
Working in bad weather is tiring and can lead to
dangerous conditions, e.g. slippery surfaces.
• Never start to work with the machine before the
working area is clear and you have a firm foothold.
• Ensure that the working area is sufficiently illuminated
to create a safe working environment.
• The machine should not be used in areas where
potential for fire or explosions exist.
OPERATING

Electrical safety

!
!
• Check that the mains voltage corresponds with that
stated on the rating plate on the machine.
• Inspection and/or maintenance should be carried out
with the motor switched off and the plug disconnected.
• Always shut down the machine before disconnecting
the power plug.
• Always unplug the machine during longer work
breaks.
• Never drag the machine by means of the cord and
never pull out the plug by pulling the cord. Hold the
plug to disconnect the power cord.
• Never use the machine if any cable is damaged, but
hand it in to an authorized service workshop for repair.
• The machine must never be driven to such a depth in
water that it reaches up to the machine's equipment.
The equipment can be damaged and the machine can
be live, resulting in personal injuries.
• Ensure that the power cable cannot be run over. Risk
of electric shock.
Grounding instructions
!
• The machine is equipped with a grounded cord and
plug and should always be connected to a grounded
outlet. This reduces the risk of electric shock in the
event of malfunction.
• The use of adaptors is not allowed with the machine.
WARNING! There is always a risk of
shocks from electrically powered
machines. Avoid unfavourable weather
conditions and body contact with
lightning conductors and metal objects.
Always follow the instructions in the
Operator's manual to avoid damage.
Never connect the machine to a outlet if
plug or cord is damaged.
WARNING! To reduce the risk of
electrical shock, do not put the grinder in
water or other liquid. Do not place or
store appliance where it can fall or be
pulled into a tub or sink.
WARNING! Improper connection can
result in the risk of electric shock.
Contact a qualified electrician if in doubt
as to whether the appliance is properly
grounded.
Do not modify the plug. If it will not fit the
outlet have a proper outlet installed by a
qualified electrician. Make sure local
regulations and ordinances are followed.
If the grounding instructions are not fully
understood contact a qualified
electrician.
–
English 15