Remote Control; Software Settings, Remote Control - Husqvarna PG820 RC Operator's Manual

Remote control

General
The floor grinder is controlled wirelessly with the remote control via radio communication between the remote control
and the floor grinder, or alternatively via the CAN cable between the remote control and the floor grinder.
For radio communication between the remote control and the floor grinder to work, the relevant remote control must be
paired with the relevant floor grinder. This is a safety measure to guarantee that the floor grinder can only be controlled
by one remote control. Radio communication does not work until this measure has been carried out. If pairing has not
yet been performed, the remote control will not be able to connect to the floor grinder via radio communication and the
display will show that it is looking for units and will try to connect, without success.
The first time the remote control is to be used together with the floor grinder, they must be paired together in order for
the radio communication to work. This may have already been done if the remote control was purchased together with
the floor grinder.
• First check that the floor grinder is active with the power cable connected and the that emergency stop on each
control panel and the machine stop on the remote control are not depressed when pairing is performed.
• Follow the instructions under Software settings, remote control below for instructions on how to pair the remote
control with the floor grinder.

Software settings, remote control

For more information on FreeRTOS, please see www.freertos.org
Remote control menu system
Use the arrow keys (2) to scroll in the menus and the "OK" button (1) to confirm the selection. Use the "back" button (3)
to go back in the menus.
3
The menu system for the remote control can be accessed by pressing the "OK" button.
The menu system comprises the following submenus:
• SETTINGS
• SERVICE
OPERATING
2 1
English – 17