Start (Remote Maneuvering); Stop (Remote Maneuvering) - Husqvarna PG820 RC Operator's Manual

Start (remote maneuvering)

CAUTION! Make sure the locking pins in
!
both wheels are depressed so that the
wheels are engaged for remote
maneuvering.
• Make sure the machine stop on the remote control is
not depressed by turning it clockwise.
• Make sure the STOP/RUN control on the remote
control is turned to STOP.
• Turn the main switch to position '1' to start the
machine. Turn the switch on the control panel to '0' for
remote operation. Start the grinding unit by turning the
STOP/RUN switch on the remote control to RUN. The
grinding unit will then start smoothly and accelerate to
the set speed within 5 seconds. During the boot, it is
default for the small engine to have about 2 sec. delay.
NOTICE! Never leave the machine unattended while
grinding.

Stop (remote maneuvering)

• Turn the STOP/RUN switch to STOP. Continue
keeping the machine in motion with the control lever
until the grinding unit stops.
34 – English
STARTING AND STOPPING