Bticino Polyx Memory Display Installation Manual page 45

PROBLEM
On pressing the Entrance panel Activation/Cycling
( ) key no picture appears
On pressing the Door lock (
mand is not performed
On pressing the OK key the menu does not switch
on and the handset gives a busy sound
When called the handset does not ring
When called the handset rings but the monitor
does not switch on
At the entrance panel it is difficult to hear the caller
At the handset it is difficult to hear the caller
SOLUTION
- check that the handset and entrance panel have
been correctly wired and configured (must have
the same P address);
- the audio/video channel may be busy, wait for it
to become free and try again.
- check that the handset and entrance panel have
) key the com-
been correctly wired and configured (must have
the same P address).
- the audio/video channel is busy, wait for it to be-
come free and try again.
- check that the handset and entrance panel have
been correctly wired and configured;
- check that the "Call Exclusion" function is not ac-
tive or that the bell volume has not been zeroed.
- check that it has not been set as "Slave".
- talk at a maximum distance of 40 centimetres
from the Polyx Memory Display microphone;
- reduce the volume of the entrance panel micro-
phone;
- you can communicate in PUSH TO TALK mode
(see the relevant section).
- check the volume setting on the Polyx Memory
Display;
- make sure that there are no strong noise sources
near the Polyx Memory Display;
- you can communicate in PUSH TO TALK mode
(see the relevant section).
Polyx Memory Display
45