Resetting To Factory Status - HomeMatic HM-RC-12 Operating Manual

Button held down: LED is illuminated in orange as long as the
button is held down and behaves as above afterward,
button held down (receiver with burst transmission mode):
Orange as long as transmitting, then feedback indicated with 1
second in red or green when held pressed.
Remote control in special mode:
LED flashes slowly in green: Configuration mode (waiting for
radio signal),
LED flashes quickly in green: Configuration mode is active and
data is being received.
LED flashes slowly in orange: Teach mode (waiting for radio
signal),
LED flashes slowly in red: Preparatory stage for resetting to fac-
tory defaults (waiting for long button press on the teach button
for resetting, or brief button press for ending).
8

Resetting to factory status

Hold the teach button down for at least 5 seconds. The remote
control LED starts to flash slowly. (If you want to abort the reset
procedure at this time, you can press the teach button briefly again
or wait 15 seconds. In either case, the flashing red will stop.)
To reset the remote control, press the teach button again for at
least 5 seconds.
The LED starts to flash in red faster while the button is held down.
Releasing the button completes the reset procedure and the LED
is illuminated for approx. 3 seconds to confirm the reset opera-
tion.
Possible error messages:
(This error can occur now if you have a center and have
taught the remote control for this center.)
If the LED does not start flashing after holding the button down
for 5 seconds but is illuminated continuously, the remote control
cannot be reset!
29