TriStar Variable Speed Pump Control ____ ____________________________Page 10 of 16
SETUP mode:
This menu allows the
user to view the prime
PRIME HEIGHT
mode that was
function
selected during initial
setup.
SETUP mode:
This menu allows the
user to define the
pump speed and
PRESET SETUP
function
duration for each
preset, which should
be customized for
each installation. Use
5 (Next) or 2 (Prev) to
select preset to be
setup.
SETUP mode:
This menu allows the
user to define the
active preset and
SEQUENCER
function
duration for each
sequence step, which
should be customized
for each installation.
Use 5 (Next) or 2
(Prev) to select
sequence step to be
setup.
Empty may be
selected if the user
does not need all of
the sequence steps.
Stop may be selected
if the user wishes to
stop the pump during
peak energy periods or
another time of day.
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Press 5 (Next) to define the
TimerOn time. To change these
settings, confirm by pressing 6
(OK). An underlining cursor will
appear below hours value. Press
5 (Next) or 2 (Prev) to select
hours or minutes to be set, and
use Time Up/Dn buttons to select
desired value. Press 6 (OK) to
store this option.
Press 5 (Next) to define the
TimerOff time. This setting is
changed the same as above.
Press 6 (OK) to display the prime
mode that was selected during
initial setup. After initial setup,
this becomes a readonly display.
For example, user stops on mode
4 (Medium High).
Using % Flow Up/Dn buttons for
currently displayed mode number
causes desired pump speed to be
set within predefined range.
Using Time Up/Dn buttons for
currently displayed mode number
causes desired time to be set
within predefined range.
Press 6 (OK) to store preset time
and % flow settings. Each preset
is set the same as above.
For example, user stops on
sequence step 1 (S1).
Use % Flow Up/Dn to select
desired active preset for displayed
sequence step, or to select Stop
Mode or Empty. If Empty is
selected, the sequence step will
be skipped, and the next step will
be active. When presets or Stop
are selected for the sequence step,
the step time defaults to the time
set for the displayed preset. This
step time may be changed using
the Time Up/Dn buttons.
Press 6 (OK) to store sequence
step settings. Each sequence step
is set the same as above.
*TMR.ON 8:00am
*TMR.ON
8:00am
*TMR.ON 8:00am
*TIMER SAVED!
*TMR.OFF 5:00pm
*MORE THAN 5 FT
(for example)
*SELECT PRESET: 4
*P4.SPEED= 20%
*P4.TIME= 1h 30m
*P4.STORED!
*S1:P1 0h30min
*S1:P3 1h45min
*S1:STOP 3h30min
*S1:EMPTY
*S1.STORED!