Table of Contents
Advertisement
6-1
Potential problems
Two types of messages appear on the display according to the nature of the problem.
Warning message
When any error occurs in parameters for auto focus, auto exposure, or paper size detection
prior to scanning, a warning message appears on the display and the Scanner stops. Warning
messages can be reset by pressing any key on the control panel. Refer to the following
pages for the action required for each message.
Error message
When any error occurs in the Scanner, an
error message appears on the display, the
start key turns red, and scanning stops. In
this case, turn the power switch off and
then back on. If the same message appears
again, check the error code (numbers
following the letter "C") and call your
authorized dealer.
Service Call
Call Tech. Rep
C15XX
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
