Montigo HW38DF Installation & Maintenance Manual page 15

45° Corner Installation.
Attach an PEL-45 (45° elbow) directly onto the flue collar. Cut the
PXT-20 to suit, and attach it to the PEL-45. Slide the fireplace into
position and attach to the termination.
Figure 14. Corner installation. (NG Models Only)
45° or less Corner Installation.
Use an PTO-4 termination and an PFL-1 or PFL-2/PFL-2 (12" or 24"
compressed length) and a frame, if appropriate. Flex may be turned
to obtain desired degree of angle required but must not exceed 45°.
Figure 14a. Flex installation. (NG Models Only)
Note: Through the wall venting kits are also available for both
the Straight and the Corner Installation. The Kit includes a heat
shield, a PFL-12 (f/f) flexible pipe, and a termination with or without
a mounting frame.
XG0147 - 150204
Installation
Corner installation is available for H38DF NG models only. Ensure minimum
vertical venting height of 42" is maintained in corner installation.
Heat Shield
PXT-18
PEL-45 Elbow
PEL-90 Elbow
Heat Shield
H*38DF Gas Fireplace
IMPORTANT
Page 15