Adding A User; Deleting A User; Blocking A User - Minicom 232 IP User Manual

13.1 Adding a user

To add a user:
1. Click
least 6 characters – letters or numbers, and must not include the user name, even
if other characters are added.
Note! The following "special" characters: &, <, >, " cannot be used for either
the user name or password.
Depending on the security level chosen the user name and password parameters
are different. See section 18 on page 23.
2. Select the permission type from the Permission box.
3. Click
shows the user level (Administrator, User, View Only). The Status column shows
whether the user is blocked or unblocked, explained in section 13.3 below.

13.2 Deleting a user

To delete a user:
1. Select the user from the list.
2. Click
3. Click

13.3 Blocking a user

An alternative to deleting a user is blocking a user. This means that the user's name
and password is stored, but the user is unable to access the system. Check Block to
block a user. Uncheck Block to allow the user access.
USER GUIDE
and type a name and a password. The password must be at
, the user appears in the list of users. The Permission column
.
, the changes are saved.
18