Product Description; Package Inclusion - aoyue Int2930 Instruction Manual

PRODUCT DESCRIPTION

The Aoyue Int2930 is a 70 Watt high performance soldering iron. It
is equipped with a quick heating ceramic heater for fast response
and heat recovery. The composite tip designs allows easy tip change
and best in class performance.
It has various functions and features such as digital offset,
System lock-out , quick jump, Temperature Scale selection and auto
sleep.
These functions will be discussed in greater detail together with
the complete features in the succeeding sections of this manual.

PACKAGE INCLUSION

1 unit Int2930 Main Station
1 pc. Soldering Iron
1 pc. 2660B Soldering Iron Stand
1 pc. Power Cord
1 pc. Instruction Manual
1 pc. Soldering Iron Stand Assembly Guide
4 4 4 4
CARE AND MAINTENANCE
1. Tip Temperature : High temperature shortens tip life and
may cause thermal shock to components.
possible temperature when soldering.
settings are 350 to 400 degrees Celsius.
2. Cleaning : Always clean the soldering tip before use to remove
any residual solder or flux adhering to it. Use a clean and moist
cleaning sponge. Contaminants on the tip
effects including reduced heat conductivity which contribute
poor soldering performance.
3. After usage: Always clean the tip and coat it with fresh solder
after use. This guards against oxidation and pro-longs tip life.
4. System Care: Never allow the unit to stay idle at high temperature
for extended periods. Utilize the automated sleep feature to
conserve energy, pro-long tip and heating element life. If unit will
not be used for long periods it is advised to power down the unit
and unplug from the mains.
5. Inspecting and cleaning the tip:
o
Set the temperature to 250 C.
◆
When the temperature stabilizes, clean the tip and check its
◆
condition. If the tip is badly worn or deformed, replace it.
If the solder plated part of the tip is covered with black oxide, apply
◆
fresh solder containing flux and clean the tip again. Repeat until all
the oxide is removed then coat the tip with fresh solder.
Never file the tip to remove oxide.
◆
Remaining oxides such as the yellow discoloration on the tip shaft
◆
can be removed with isopropyl alcohol.
Always use the lowest
Standard temperature
have many detrimental
to
13 13
13 13