Toyota Corolla Instruction Manual page 94

94
2. Instrument cluster
 The meters and display illuminate when
Vehicles without a smart entry & start system

The engine switch is in the "ON" position.
Vehicles with a smart entry & start system

The engine switch is in IGNITION ON mode.
When disconnecting and reconnecting battery terminals

The following information data will be reset:
Average fuel consumption

 Driving range
CAUTION
 The display at low temperatures
Allow the interior of the vehicle to warm up before using the display. At
extremely low temperatures, the display monitor may respond slowly, and
display changes may be delayed.
For example, there is a lag between the driver's shifting and the new gear
number appearing on the display. This lag could cause the driver to down-
shift again, causing rapid and excessive engine braking and possibly an
accident resulting in death or injury.
 Cautions during setting up the display
As the engine needs to be running during setting up the display, ensure that
the vehicle is parked in a place with adequate ventilation. In a closed area
such as a garage, exhaust gases including harmful carbon monoxide (CO)
may collect and enter the vehicle. This may lead to death or a serious
health hazard.
NOTICE
 To prevent damage to the engine and its components
 Do not let the indicator needle of the tachometer enter the red zone, which
indicates the maximum engine speed.
 The engine may be overheating if the high engine coolant temperature
warning light comes on. In this case, immediately stop the vehicle in a safe
place, and check the engine after it has cooled completely. (P. 579)
Corolla_TMMT_EE (OM12F04E)