Toyota Corolla Instruction Manual page 553

With the compressor switch off, disconnect the hose from the valve
15
on the tire and then pull out the power plug from the power outlet
socket.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired tire.
16
Attach the air release cap to the
17
end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
Temporarily store the bottle in the trunk while it is connected to the
18
compressor.
To spread the liquid sealant evenly within the tire, immediately drive
19
safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving for about 5 km (3
20
miles), stop your vehicle in a
safe place on a hard, flat sur-
face and remove the air release
cap from the hose before
reconnecting the repair kit.
Corolla_TMMT_EE (OM12F04E)
7-2. Steps to take in an emergency
553
7