Cleaning and replacing the rear air filters
Before changing the filters, always make sure the projector is switched off and fully disconnected
from its power supply.
When changing the filters, avoid using excessive force as this may damage the equipment.
1.
Loosen the two knobs
holding the filter cover by
turning them counterclockwise.
Use a Phillips screwdriver if
necessary.
The knobs are not
removable.
2.
Tilt the filter cover to open it.
3.
Remove the filters. Grasp the
top and bottom or left and
right ends of each air filter and
remove it by pulling toward
you.
1
1
1
Important Information
Page 33