Maintenance; Cleaning Or Replacing The Filters - NEC VT58 User Manual

Hide thumbs Also See for VT58:

Table of Contents

6. Maintenance

This section describes the simple maintenance procedures you should follow to clean the filters and replace the lamp.

The air-filter sponge keeps dust and dirt from getting inside the projector and should be cleaned after every 100 hours

of operation (more often in dusty conditions). If the filter is dirty or clogged, your projector may overheat.

CAUTION

•

Turn off the projector, turn off the main power switch and unplug the projector before replacing the filters.

•

Only clean the outside of the filter cover with a vacuum cleaner.

•

Do not attempt to operate the projector without the filter cover.

To clean the air-filter:

Vacuum the filter-through the filter cover.

To replace the filter (sponge):

1. Remove the filter cover by pushing down on the catch of the cover until you feel it detach.

NOTE: The VT580 and VT480 have two filters; the VT58 and VT48 have one filter only.

2. Gently peel off the filter (sponge) and replace it with the new one.

VT58/VT48

VT580/VT480

Catch

Table of Contents

Vt48 Vt580 Vt480 Vt58/be Vt48/g