Table of Contents
Advertisement
Important Information
Connecting the power supply
When the projector is viewed from
the back, the AC mains inlet
is located on the right hand side,
toward the rear.
Make sure the power switch
2
above the inlet is in the OFF
position, then push the mains
connector in firmly.
Ensure that the power outlet
includes a ground connection
as this equipment MUST be
earthed.
Handle the power cable
carefully and avoid sharp
bends. Do not use a damaged
power cable.
Switching the projector on
1.
Make sure the power switch above the AC mains inlet is in the OFF position. Connect the power
cable between the mains supply and the projector, then turn the power switch on.
The
status indicator lights a steady amber to show that the projector is now in
SYSTEM
STANDBY mode.
2.
(optional step) If no button is pressed within
30 seconds of the projector entering STANDBY
mode, the control panel becomes locked.
To unlock the control panel, press and hold the
button for one second or longer.
KEY LOCK
3.
To switch from STANDBY to ON mode, press
and hold the
POWER
longer.
During the startup process, the
indicator flashes green. When the projector is fully
switched on, the
steady green.
Page 22
1
See Connecting the power supply above.
button for three seconds or
SYSTEM
status indicator lights a
SYSTEM
status
1
2
Advertisement
Table of Contents
Need help?
Do you have a question about the NP-PH1201QL and is the answer not in the manual?
Questions and answers