Disposal; Manufacturer's Warranty - Tools - Hilti TE 1000-AVR Original Operating Instructions

Fault
The power tool doesn't start
and the service indicator blinks
red.
The power tool cuts out while
running and the service indic-
ator lights red.
The power tool doesn't achieve
full power.
The chisel can't be released
from the chuck.
NOTE
If the fault can not be eliminated by the measures listed above, have the power tool checked by Hilti Service.

10 Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.

11 Manufacturer's warranty - tools

Please contact your local Hilti representative if you have
questions about the warranty conditions.
Possible cause
The voltage provided by the electric
supply is too high.
The overheating prevention cut-out
has been activated.
Power reduction is active.
The extension cord is too long or its
gauge is inadequate.
The voltage provided by the electric
supply is too low.
The chuck is not pulled back fully.
Remedy
Use a different power outlet.
Check the electric supply.
Allow the power tool to cool down.
Clean the ventilation slots.
Press the power level selector switch
(observe the power level indicator).
Unplug the power tool from the elec-
tric supply and then plug it back in.
Use an extension cord of an
approved length and / or of adequate
gauge.
Connect the power tool to a different
power source.
Pull the chuck back as far as it will go
and remove the insert tool.
en
25