York Fitness YBR-AC-120 Owner's Manual page 9

Operational Instructions
Hand Pulse Sensors
This exercise cycle is fitted with 2 hand pulse sensors. To obtain
a pulse reading you must have both your left and right hands on
the sensors at the same time. Do not grip the hand sensors too
Hand Pulse Sensor
tight to give the computer a few seconds to display the reading.
Adjusting The Resistance
This exercise cycle features a speed independent braking
(resistance) system. The resistance is controlled by a magnet,
Resistance Level
which is moved closer or further away from the flywheel - the
closer the magnet is to the flywheel the higher the resistance.
The magnet is computer controlled, to adjust simply use the UP /
DOWN key on the console.
Adjust the seat
1. Unscrew the hand wheel.
2. Adjust the seat up / down or forward / backward to your liking.
3. Re-screw the hand wheel - make sure it is screwed tightly.
4. The basic rule for getting the seat height right is that as the
pedal reaches its lowest point, the leg is almost straight.
Note: Do not pull the seat out too far - the maximum is indicated
with a piece of tape on the seat post.
Levelling Your Exercise Cycle
To help you level the exercise cycle on uneven surface, 2 height
adjusters are included on the rear stabilizers. Simply twist these
around to adjust the height of the cycle.
www.yorkfitness.com 9