Fan Belt; Tires - Branson 00 series Operator's Manual

18. FAN BELT

【Otherwise】
There is a risk of getting burnt．
Open the engine hood and side covers and press the middle of fan
belt with finger to see if the belt sags about 0.4 ~ 0.6in(A) or if
there is any damage to the belt. If the sagging is not correct,
loosen the generator bolts(1) and move the generator(B) to adjust
the tension of the fan belt. If the fan belt still slips after the
generator is moved to the maximum, replace the belt with a new
one. New belts must be inspected after 50 hours of running.

19. TIRES

Adjust air pressure in front and rear tires to standard pressure.
Also, check if there are any cracks on the tires.
When front wheels are put under a load of the front weights or a front loader, air pressure in the front
wheels must be adjusted to the maximum in the chart as followed.
Air pressure in tires
Front
With
Implement
Rear
Front
With
loader
Rear
Torque of wheel bolts
Type
Front wheel
Rear wheel
Carry out inspection
maintenance after the engine
is fully cooled down．
Air pressure(psi)
10/20 series
29
19
44
29
Torque (lb-ft)
130 ~ 145
130 ~ 145
- 79 -
or
High Standard Low