Filter Replacement - Branson 00 series Operator's Manual

Front Axle Fluid
Checking
Open the fluid filler cap at the upper right side of the front axle,
clean the tip of the gauge, dip the cap without screwing in, and
take it out again to read the fluid level. Refill the fluid as
necessary, and also check for leaks.
Change of Fluid
Drain the fluid through three drain holes under the front axle.
Refill the fluid from the upper right side of the front axle.

6. FILTER REPLACEMENT

Engine Oil Filter．
Replace it every 300 hours or when engine oil is changed.
Note : First 50hr filter has to be changed.
Replacement
(1) After draining the engine oil, turn the cartridge to the left
with the filter wrench．
(2) Apply a thin film of oil over the rubber ring on the bottom of
the new cartridge and attach the new filter securely.
(3) After changing the engine oil, start the engine and run it
until the engine oil pressure warning lamp is turned off
(4) After the oil pressure warning lamp is turned off, check the
oil level again. Add oil as necessary.
- 70 -