Branson 00 series Operator's Manual page 73

Replacement
(1) Open the radiator cap and the drain plug to completely drain the water from the radiator．
(2) Rinse the radiator with tap water until no dirt or rust comes out.
※ For better results, fill the radiator with water mixed with radiator flush, run the engine for over 15
minutes, and drain the water solution．
(3) Replace the drain plug, add anti-freeze and fill the radiator with tap water.
(4) Replace the radiator cap and run the engine to mix the anti-freeze and water
[Handing of Anti-Freeze]
Anti-freeze has an effect of lowering the freezing point of water. This tractor is filled with
international genuine anti-freeze when delivered from the factory. As the freezing point may differ
depending on the mixture ratio, refer to the following table in very cold weather to ensure safety.
Anti-Freeze Mixture Ratio
Outdoor Temp ('F)
Ratio (%)
Anti-Freeze (%)
【Precaution】
• When replacing the coolant, add anti-corrosive solution and run the engine for
about five minutes to mix it with the water.
• For correct mixture ratio, refer to the manufacturer's instructions.
• When refilling the coolant, add only tap water.
• As anti-freeze expires in one year, replace the coolant every year．
23 14 5
82 73 66
18 27 34
73
．
-4 -13 -22
61 55 49
39 45 51