Instrument Panel - Branson 00 series Operator's Manual

E. INSTRUMENT PANEL
Meter Panel
PTO Lamp
Fuel Gauge
Hour Meter
Park Brake Lamp
1. Thermostat warning lamp
Lamp will come on when the ignition switch is put into the "ON"
position with outside temperature of around 40°F, indicating that
electricity is supplied to the heater or glow plugs. Turn the ignition
switch to "START" after the lamp has been turned off (it is turned off
automatically) then it will start the engine
thermostat stays on will depend on the temperature of the
engine coolant.
Coolant temp
2. Charge pilot lamp
It will be turned on when the key switch is put into the "ON" position,
and will be turned off when the battery starts being charged after
engine is started and the engine revolution increases. The battery
will not be charged with the engine below 1,000 rpm. (The rpm
should be 1,500 rpm or higher)
. The length of time the
32°F ~ 60°F 10sec
32°F ~ 5°F 20sec
- 39 -
PTO Position
Head lamp High beam
Pre-heat Lamp
Engine oil pressure
Pilot lamp
Battery Charge Lamp
Water Temp Gauge