Table of Contents
Advertisement
Flue:
Flue Cowl:
Gas Connection:
Power:
Fan:
Gas Types:
Inlet Pressure (nominal)
Supply Pressure (min/max)
Gas Rate: (high/low)
Pressure (high/low)
Pilot Injector:
Main Injector:
Primary aeration:
Burner:
Gas Control:
Ignition:
Flame Monitoring:
Control:
Notes on Installation:
External Glass
This fire is able to be installed as either a room divider or on an external wall with the addition of a piece of toughened
glass. The manufacturer takes no responsibility for providing the means of meeting any regulatory or other building
requirements. There are more details on this option covered in the framing section on page 10.
Gas Supply
A suitable gas supply needs to be provided to the left hand rear corner of the installation cavity. The pipe sizing should
be calculated to supply at least 67 MJ/h.
Allow sufficient pipe to make the connection as shown below (Refer to the Commissioning section for details on gas and
power connection, page 12).
Electrical Supply
The fire is supplied with a power lead approx. 1.8 m long and fitted with a three pin plug. This needs to be plugged into
a socket, provided by an electrician, located preferably to the left of the fire, but somewhere that the power cord will not
be exposed to excessive heat. This socket need to be connected to an isolating wall switch, facing into the room.
This switch is used to isolate all power for servicing etc. but is not required for the normal operation of the fire.
The power cord is designed for a 20/240V a.c. 10 amp supply.
Electrical connection must comply with AS/NZS 000.
Natural draught flue system using 2 Ø200~250 twin skin flues with optional Y adaptor
to single Ø250~00 twin skin flue (inner to be stainless steel)
Minimum of 2.4 metres of flue, .6 metres if off-set bends are used
AGA Approved 200 mm flue cowl
Male Flare on gas control /8" BSPF
20/240V a.c. 50hz, 1 Amp
Tangential; 2 speed (electronic)
Natural gas
1.5 kPa
1.0/5.0 kPa
67/40 MJ/h
0.7/0.25 kPa
0.45 mm
2 x Ø .0 mm
20mm sleeve
( grooves)
Bunsen type atmospheric
SIT 845 with SIT 579.506 DBC modulating control
Electronic
Flame rod
Electronic Control with IR remote
1.7 Metres
(Min)
~300
ULPG
2.75 kPa
2.0/.5 kPa
67/40 MJ/h
1.7/0.6 kPa
0. mm
2 x Ø1.8 mm
nil or 10mm
(2 grooves)
Glass Side
Open Side
5
(pebbles or crystals ONLY)
Advertisement
Table of Contents
