Table of Contents
Advertisement
Place (DO NOT POUR*) all of the supplied Pebbles or Glass evenly across the entire area of the burner. The finished
depth will be about 2~ pebbles or about 20 mm of glass. Take care to keep the area directly around the pilot burner
clear of burner media.
Do not pile glass or pebbles over the top of the pilot assembly as this could affect its performance. It may be possible
to build the media up around the pilot to hide it slightly but always check that the pilot is operating at its optimum when
finished.
* Pouring the media over the burner can block the burner ports with the fine dust that tends to settle in the bottom of the
bags during shipping
Trim Installation
Notes:
The outer trim panel cannot be installed until the wall board has been attached and finished (decorated)
It is recommended that the installation of the trims and burner media is left until the room is complete and all decoration
is finished.
Leave the protective cardboard cover taped to the front of the firebox using a low-tack tape to prevent plaster dust and
debris from entering the firebox and damaging the paint work.
Fit the Minimal Trim so that the two hooks in each end fit over the screws in the side of the firebox as shown below.
Fix the trim in place using an earthing screw (with captive washer) in one end of the trim.
Fit the reflectors by fitting over the front trim at an angle and the standing up against the side of the firebox. Hold in place
by lifting the reflector retainers and dropping into the slot on top of the reflector.
Pull the two spring loaded Lower Trim Retainers forward and down and then across until they lock in place as shown.
Fit the outer trim over the Upper Trim Hooks. If adjustment of the hooks is required, use a screwdriver to prise the hooks
forward, or push them back until the trim fits flush with the wall.
Hold the leg of the trim against the Lower Trim Retainer and push the retainer across and it will snap up and into the slot
on the back of the trim, the spring Retainer will pull back into the cavity once the bracket is horizontal again.
WARNING: Take care when the spring grabs that the trim is not resting on the hearth as it could bite into the
surface and scratch it. Either hold the trim slightly higher or use a thin piece of card between the leg end
and the hearth.
EARTHING SCREW
REFLECTOR
2
1
MINIMAL
TRIM
REFLECTOR
RETAINER
REFLECTOR
UPPER
TRIM
HOOK
17
3
2
1
LOWER
TRIM
RETAINER
Advertisement
Table of Contents
