Table of Contents
Advertisement
Flue requirements
The minimum fl ue height is 2.4 metres The fl ue cowl should be no lower than 900mm vertically from the roof line
and a 2 metre horizontal clearance from any part of the building, see cowl clearance drawing.
Model
Real Fire 650
Real Fire 700
Real Fire 800
Real Fire 900
Real Fire 1000
Real Fire 1200
The Real Fire 1500 has Two Flues
There are two fl ue spigots on top of the insulation kit. Two 150mm/200mm x 1200mm long sections of fl ue are
connected to the spigots. The two fl ues are then connected to a special Y piece, this is a transition to join the
two fl ues into one. From the Y piece a single 250/300mm fl ue kit is used with a 250/300 cowl.
Installation instructions
Firstly the fi rebox and fl ue are installed and then the burner is installed. The burner may be installed at a later date
when all the construction work is complete and the hearth is in place.
The fi rebox is placed on the platform provided and the gas pipe is pushed through the hole at the right hand rear
of the fi rebox (RH from the front of the fi re).
This pipe is to be connected to the burner but may be left sealed if the burner is to be installed later. Leave enough
pipe to connect the burner.
Once the fi rebox is in place ensure it is level. Usually the fi rebox is positioned centrally and so that the fl ange
around the fi rebox opening is left forward of the timber framing by 10mm, this is to allow for giboard to be fi xed
behind the fl ange.
Flue and Cowl Size
Flue
150mm inner fl ue/ 200mm outer fl ue
150mm inner fl ue/ 200mm outer fl ue
200mm inner fl ue/ 250mm outer fl ue
200mm inner fl ue/ 250mm outer fl ue
200mm inner fl ue/ 250mm outer fl ue
250mm inner fl ue/ 300mm outer fl ue
Cowl Size
150/200 Cowl
150/200 Cowl
200/250 Cowl
200/250 Cowl
200/250 Cowl
250/300 Cowl
realfi res.co.nz
Advertisement
Table of Contents
