Tv Recesses; Flue Requirements - Realfires RF1200TW Installation Manual

TV Recesses

The only restrictions to installing a television above the fire are those
imposed by the manufacturer of the television but as a guide it is
recommended that the television is either installed into a recess or
with a mantle below it and the front face of the television is at least
20mm back from the front of the mantle or recess. All other clearance
requirements in this guide must be followed.

Flue requirements

Only used AGA approved cowl/s
The fire is fitted with two Ø200~250 flue spigots and standard flue components should be used. A Y piece collector is
available from Real Fires that allows the two flues to be joined into one Ø250~00 to be finished using standard twin
skin flue and flue cowl. It is recommended that the 200~250 mm flue is taken vertically as high as practicable before
joining using the Y piece. The Y piece is not required and the fire can be flued using two separate 200/250 flues through
to termination.
Y Piece Installation Instructions:
Fit the first lengths of flue onto the firebox using rivets and sealant as required
Fit the Ø200 stainless steel 45° bends but do not fix in place yet
Fit the Ø250 galvanised 45° bend and leave loose
Fit the two short lengths of stainless steel flue and Y-Piece and square up the whole assembly and fix in place
Fit the two galvanised bends and galvanised over-wraps and fix in place
Complete the flue using Ø250 stainless steel inner and Ø00 galvanised outer flue as required
The minimum total flue height is 2.4 metres, providing the flue is straight without offsets.
Offsets can be used on flues over .6 metres in height.
The flue and cowl must be installed in accordance with AS 5601/NZS5261
Ø300mm galvanised
flue section
Ø250mm stainless
steel flue section
Ø200mm stainless
steel flue section
Ø250mm galvanised
flue section
Y-Piece*
Ø250mm galvanised
over-wrap *
Ø200mm stainless
steel flue section *
Ø250mm galvanised
45° bend *
Ø200mm stainless
steel 45° bend *
* included in Y-Piece Flue Kit
7
* While using a non-combustible
material will allow the gap to be
reduced there could be some
heat that conducts through from
the flue/s into the TV Cavity so
25 Min if
the gap should be maximised
backing is
combustible
material *