Table of Contents
Advertisement
Burner Media Installation
Note: Do not place anything other than the Real Fires supplied burner media on the burner
Logs/Coals and Granules
This option consists of:
•
~280 gms Ceramic Granules (approx. 10~20mm chunks)
•
60 Ceramic Coals (50 x 50 x 50 mm ±10)
•
4 ceramic Logs (Ø40 x 200 mm long – 2 straight, 2 Y's)
•
4 ceramic Logs (Ø5 x 150 mm long )
•
12 Ceramic logs (Ø25 x 150 mm long)
Note: the logs and coals can be set onto the burner while out of the fire but care must be taken not disrupt the setup
whilst fitting the burner into the firebox.
Place approximately 46 coals onto the burner top taking care to not block to many burner ports. There is no set way to
place the coals but the following diagram can be used as a guide. Take care not to cover the aeration slots on the front
of the burner or block the pilot and tracking holes on the burner top.
Carefully place the granules onto the burner in a single layer that covers some of the holes in places where they may be
seen when finished and also around the front and back of the burner as a decoration.
Place the remaining coals and all of the supplied logs onto the burner leaving plenty of gaps between logs and coals.
Once all the logs and coals are in place, light the fire and assess the look of the flames. If there are any areas that have
very long streaky flames then, using a pair of tongs, move the top logs or coals to another position until the flames are
more even across the whole burner.
Pebbles / Glass
Description:
Pebbles; approximately 1500 white ceramic pebbles, about 20mm in diameter and 10mm thick
Glass; approximately 8 kg of 1 mm crushed glass (available in various colours) the size of the pieces vary from about
5 to 15 mm.
16
Advertisement
Table of Contents
