Key And Headlight Switch Operation; Direction Selector Operation - Cushman Hauler 800XE Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
When you drive the vehicle at full speed on a dirt road, loose surface or wet grass, the necessary distance to stop the
vehicle will increase. The necessary distance to stop a loaded vehicle is more than the necessary distance to stop a vehi-
cle without a load. In wet weather conditions, apply light pressure to the brakes to supply enough friction to dry the brake
unit. Wet brakes lose much of their effect.
If you drive on a steep hill and can not get enough traction, do not try to turn around on the hill. Slowly drive in the
reverse direction and use the brake to control the speed.

Key and Headlight Switch Operation

When you leave the vehicle, turn the key to the OFF position and remove from the switch to pre-
To prevent possible damage to the components, stop the vehicle before you move the key switch or the direc-
Turn the key to the right to enable the electrical system of the vehicle. The first stop is ON and supplies power that allows
you to drive the vehicle. The second stop has a light icon and activates the lights.
When you leave the vehicle, turn the key to the OFF position and remove the key from the switch.
If the vehicle has accessories that were installed at the factory, some acces-
sories continue to operate with the key switch in the OFF position.

Direction Selector Operation

To prevent loss of control, do not move the direction selector to a different position while the vehi-
cle is in motion. If you move the selector, the speed will immediately decrease and a warning
Move the direction selector to F to move in the forward direction.
Move the direction selector to R to move in the reverse direction. A reverse warning buzzer activates when the direction
selector is moved to the R position.
The position between F and R is the neutral position.
When you leave the vehicle, put the direction selector in the neutral position, engage the parking brake and remove the
key from the switch.
OPERATING PROCEDURES
vent accidental operation.
tion selector to a different position.
device activates.
Owner's Guide
B
Key and Headlight
Switch
Direction
Selector
21