Walk-Away Feature; Anti-Roll Back Feature; Anti-Stall Feature; High Pedal Disable Feature - Cushman Hauler 800XE Owner's Manual

OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
between 8 and 3 mph (5 kph), or the accelerator pedal is applied. The warning beeper will not activate. When pedal-up
braking is activated by this sequence of occurrences, the motor generates power which is returned to the batteries.
B

Walk-Away Feature

Walk-Away limits vehicle movement without driver input, decreases vehicle speed to 2 mph (3 kph) and activates an
alarm (reverse beeper).
Example: If all of the following events occur:
• the vehicle is stopped for more than 1.5 seconds
• the accelerator pedal is released for more than one second
• the vehicle starts to move at more than 2 mph (3 kph)
the Walk-Away feature limits speed to approximately 2 mph (3 kph) and the warning beeper activates. When the acceler-
ator pedal is pressed, the Walk-Away feature and warning beeper stops and normal vehicle operation continues.
When the TCT system senses any condition that is not normal, it responds in a similar manner.
The system functions in all key switch positions.

Anti-Roll Back Feature

Anti-Roll Back, like Walk-Away, limits reverse motion of the vehicle down a slope to less than 2 mph (3 kph). See Walk-
Away Feature for more information.

Anti-Stall Feature

Anti-Stall protection prevents motor damage if the vehicle is stalled against an object or on a hill.
Example: If all of the following events occur:
• the system senses that the accelerator pedal is pressed (power applied to motor)
• the motor is stopped long enough that additional time can cause damage to the motor
the Anti-Stall feature will interrupt power to the motor. This short interruption allows the vehicle to move backward slightly
before it stops again. The procedure will repeat at intervals until the vehicle is moved from the stopped condition.
Example: If all of the following events occur:
• the system senses that the accelerator pedal is pressed (power applied to motor)
• the brake is engaged to prevent vehicle motion
the Anti-Stall feature senses a stalled motor condition and removes power from the motor. When the brake pedal is
released, the vehicle will move backward slightly before power is returned to the motor.

High Pedal Disable Feature

High pedal disable prevents acceleration of the vehicle if the direction selector is changed or the key is turned on while
the accelerator is pressed.

Diagnostic Mode Feature

Diagnostic mode helps with fault diagnosis.
With some electrical system failures, the Diagnostic Mode feature defaults to a mode that allows the vehicle to operate at
a decreased speed.
This feature allows you to return the vehicle to the storage facility and identify the problem.
The technician can put the controller in diagnostic mode and the controller identifies the failure mode.
28 Owner's Guide