Controls And Indicators; Key/Light Switch; Direction Selector; State Of Charge Meter - Cushman Titan 36V Owner's Manual And Service Manual

OPERATION AND SERVICE INFORMATION
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

CONTROLS AND INDICATORS

Vehicle controls and indicators consist of:
•
key/light switch (lights optional)
•

direction selector

•

state of charge meter

•

hour meter

•
accelerator pedal
•
foot brake pedal
•
Hand operated park brake
•
Direction selector lever (36V models only)
•
Direction selector switch (48V PDS models only)
•
Run - tow/maintenance/Storage switch (48V PDS
models only)
•
Horn

Key/Light Switch

Located on the dash panel, this switch enables the basic
electrical system of the vehicle to be turned on and off by
turning the key. To prevent inadvertent operation of the
vehicle when left unattended, the key should be turned to
the 'OFF' position and removed (Ref Fig. 3 on page 2).
DASH PANEL (36V)
Horn
DASH PANEL (48V PDS)
Horn
Fig. 3 Key/Light Switch, State of Charge Meter, Horn
and Hour Meter
Page 2
Blank Switch
Hour Meter
State of Charger Meter
ON
OFF
Key Switch
FNR Switch
Hour Meter
State of Charger Meter
ON
OFF
Key Switch
Owner's Manual and Service Guide
If the vehicle is equipped with lights, the key switch has a
position to operate them, indicated by the light icon.
Direction Selector
To prevent loss of control, do not move Preci-
sion Drive System (PDS) vehicle direction
selector while the vehicle is in motion. Moving
the selector will result in a sudden slowing of
the vehicle and the beeping of a warning
device.
To reduce the possibility of component damage, the
vehicle must be completely stopped before moving the
direction selector.
On PDS models, if the direction selector is shifted before
the vehicle comes to a complete stop, a warning beeper
will activate.
Located on the dash panel or between seats, this lever or
switch permits the selection of either 'F' (forward), 'R'
(reverse) or neutral (the position between forward and
reverse). Vehicle should be left in neutral when unat-
tended (Ref Fig. 4 on page 2)
.
FWD
REV
Neutral
Reverse
Fig. 4 Direction Selector Types
State Of Charge Meter
Located in the dash, the state of charge meter indicates
the amount of usable power in the batteries (Ref Fig. 3
on page 2).
Hour Meter
Located in the dash, the hour meter indicates total hours
of operation.(Ref Fig. 3 on page 2)
Forward
Neutral, as shown
Reverse
Forward