Wheels And Tires - Cushman Hauler 800XE Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
2. Put the jack at the center of the front axle.
3. Lift the vehicle enough to put two jack stands below the front frame crossmember as shown.
4. Lower the jack and test the stability of the vehicle on the two jack stands.
Lower the vehicle:
1. Lift the vehicle enough to remove the jack stands.
2. Carefully lower the vehicle to the ground with the jack.

WHEELS AND TIRES

Recommended tire inflation pressure: 18-22 psi
To decrease the risk of tire explosion, do not exceed the tire inflation pressure rating on the tire
To decrease the risk of tire explosion, inflate small amounts of air into the tire at intervals to seat
beads. Because of the low volume of the small tires, over inflation can occur in seconds. Never
exceed the tire inflation pressure rating on the tire sidewall when seating a bead. Protect the face
When you remove the wheels, use only sockets made for impact wrenches to decrease the risk of
Do not use tires with low rated pressure. Do not use tires that have a recommended tire inflation
pressure less than the tire inflation pressure recommended in the owner's guide.
Do not over inflate the tires. Excess pressure can cause the tire to separate from the wheel or
Flat Portion
of Frame
Outside End
of Rear Axle
and eyes when you remove a valve core.
injury by a broken socket.
cause a tire explosion.
View from Underside of Vehicle
sidewall.
Owner's Guide
MAINTENANCE
Center of
Front Axle
B
33