Toshiba T2200SX User Manual page 185

with the guide pin on the LCD cover.
6. Connect the two display signal cables to CN1 and CN2 on the left side of the LCD module.
CAUTION: Be extremely careful not to damage any components on the LCD module.
7. Route the FL inverter board power cable along the bottom of the LCD module and then
position this cable under the white FL lamp cable located at the lower right corner of the
LCD module.
8. Turn the FL inverter board so that the back is facing you and then connect the three FL
inverter cables to CN1, CN2, and CN3 on the FL inverter board (Figure 6-16).
9. Rotate the FL inverter board to the right and place it into the LCD cover. Align the bottom
of the FL inverter board with the guide pin on the LCD cover.
10. Install the two (M2x4) screws to secure the FL inverter board to the LCD cover (Figure
FL inverter
board
M2x4 screws
6-16).
11. Install the two display supports. Then replace the one (M2.5x6 silver) screw to secure the
ground wire and the one (M2.5x4) screw to secure the right corner of the lower display
support (Figure 6-17).
CAUTION: The lower display support should house the black FL inverter board power
cable. Make sure this cable is not pinched by the display support before replacing the
Figure 6-16 Installing the FL inverter board
FL inverter cable
CN2
CN3
CN1
FL inverter cables
UPDATE
6-17