Toshiba T2200SX User Manual page 181

6. Position the two ground plates on the connector panel bracket and then install the two
(M2x4) screws for the connector panel bracket (Figure 6-10).
M2x4 EXP memory
connector screws
M2x4 connector
panel bracket
screws
Figure 6-10 Installing the connector panel screws and ground plates
7. Install the metal card puller assemblies for the card modem and memory card.
8. Turn the middle base assembly over and place it into the computer.
9. Place the connector panel edge into the computer. Guide the mylar pull tab for the memory
card through its slot on the top cover.
10. Install the ground plate over the system board, but under the middle base assembly.
11. Install the five (M2x4) screws to secure the system board (Figure 6-11).
12. Install the four (M2x4) screws to secure the middle base assembly (Figure 6-11).
Figure 6-11 Installing the system board and middle base assembly screws
13. Replace the one (M3x6 silver) ground terminal screw at the back of the computer.
ground
plate
M2x4 screws
ground plate
card puller
assemblies
M3x6 silver ground
terminal screw
UPDATE
M2x4 modem
connector screws
M2x4 screws
6-13