Procedure 3
Connector Check
The power supply board is connected to other units by some cables. Any of these cables may be
disconnected from the power supply board. Refer to Chapter 5 for instructions on how to disas-
semble the T2200SX and then perform the following check.
Check 1
Make sure that the following cables are connected to the power supply board cor-
rectly.
Battery Terminal connector
System Board connector
(This in a direct connection between the power supply board and the system board.)
Sub Battery connector
If any of these cables are disconnected, connect them. Test the computer again for
PJ1
Power Supply Board
PJ2
Power Supply Board
PJ4
Power Supply Board
PJ3
Power Supply Board
3-11