11.
Rest the system board assembly on the system board support block behind the computer to
support the flexible cables and connector panel.
CAUTION: If stressed, the HDD cable can easily rip at the fold in the cable.
Therefore, make sure the HDD cable rests in the same position on the support block as
when the HDD is assembled in the computer.
12.
Remove the four special screws securing the HDD to the middle base assembly. Separate
special screws
the HDD from the assembly (Figure 5-19).
Figure 5-18 Removing the middle base assembly
HDD
middle base
assembly
special screws
5-19