Rear Panel - Alcatel OmniSwitch 6800 Series Hardware User's Manual

OmniSwitch 6800 Series Chassis and Hardware Components

Rear Panel

The rear panel of OmniSwitch 6800 Series switches contains the following major components:
Factory-installed power supply and power connector socket (all OmniSwitch 6800 Series switches)
•
Backup power supply bay for optional OS6800-BPS power supply (all OmniSwitch 6800 Series
•
switches)
Stacking ports (all OmniSwitch 6800 Series switches except for the OmniSwitch 6800-U24)
•
10 Gigabit XFP module slot (all OmniSwitch 6800 Series switches except for the OmniSwitch 6800-24
•
and OmniSwitch 6800-24L)
Power Connector Socket Type IEC-320-
C13. Supports one 10 amp power cord.
OmniSwitch 6800 Series switches do not
provide on/off switches; the power cord is
the switch's only disconnect device.
It is recommended that you use only Alcatel-
provided power cords.
Backup Power Supply Bay
Slot for optional user-installable OS6800-BPS
backup power supply connector. For more
information on the backup power supply, refer
to the sections,
Power Supply Shelf" on page 2-42
"OS6800-BPS 225W Backup Power Supply"
on page 2-44.
OmniSwitch 6800 Series Hardware Users Guide
Stacking Ports A and B
Connector ports for use in stacking OmniSwitch 6800
Series switches into a virtual chassis. For detailed
information on stacking switches, refer to
as well as
Stacks" on page
Note: The OS6800-U24 does not support stacking. On
these switches, this section of the rear panel is blank.
"OS6800-BPS-SHLF Backup
and
OmniSwitch 6800 Series Rear Panel
July 2005
"Managing OmniSwitch 6800 Series
3-1.
Stack A Stack B
10 Gigabit XFP Module Slot
Reserved for use with two-port 10 Gigabit XFP
module. Refer to "OS6800-XNI-U2 10 Gigabit
Expansion Module" on page 2-34
tion.
Note: The 10 Gigabit XFP Module is not supported
on OS6800-24 and OS6800-24L switches. On these
switches, this section of the rear panel is blank.
Rear Panel
page 2-22,
for more informa-
page 2-15