Alcatel OmniSwitch 6800 Series Hardware User's Manual page 77

OmniSwitch 6800 Series Chassis and Hardware Components
3
With one hand, grasp the handle at the front of the power supply. Place your other hand under the
power supply casing to support its weight. Carefully insert the rear of the casing into the power supply bay
and slide the power supply back along the chassis alignment guide until its connector meets the chassis
backplane connector.
4
Continue sliding the power supply back until the front panel is flush with the rear panel of the chassis.
Do not force the power supply into the bay. Otherwise you can damage the connectors.
5
Tighten the two captive screws, located at the left and right sides of the power supply's front panel. Be
sure not to overtighten the captive screws. If you use a screwdriver, the torque used to tighten the screws
must not exceed 2.3 inch pounds.
6
Connect the power supply cord (provided) into an easily accessible power source.
Note. If you are installing multiple backup power supplies in the power shelf, install all remaining units by
repeating steps 1 through 6 for each supply.
OmniSwitch 6800 Series Hardware Users Guide
Inserting the Backup Power Supply
Tightening the Captive Screws
July 2005
Backup Power Supply Components
Chassis Alignment Guide
page 2-49