Alcatel OmniSwitch 6800 Series Hardware User's Manual page 52

Setting Up a Stacked Configuration
5
To provide added resiliency and redundancy, you must install the redundant stacking cable to connect
the top switch in the stack to the bottom switch. Connect the redundant cable now. Refer to the diagram
below for more information:
6
Once all stacking cable connectors are inserted, tighten the captive screws at the left- and right-hand
sides of each connector, as shown. Be sure not to overtighten the screws.
7
Now that all switches in the stack are connected, continue to
Switches" on page 2-25.
page 2-24
Redundant Connection Between Top and Bottom Switches
Tightening Stacking Connector Captive Screws
OmniSwitch 6800 Series Chassis and Hardware Components
"Booting OmniSwitch 6800 Series
OmniSwitch 6800 Series Hardware Users Guide July 2005