Os6800-Xni-U2 10 Gigabit Expansion Module - Alcatel OmniSwitch 6800 Series Hardware User's Manual

OS6800-XNI-U2 10 Gigabit Expansion Module

OS6800-XNI-U2 10 Gigabit Expansion Module
OmniSwitch 6800-48, 6800-U24, and 6800-48L switches support a 10 Gigabit expansion module
(OS6800-XNI-U2). The slot for the expansion module is located at the rear panel of the switch chassis.
The 10 Gigabit Ethernet expansion module supports up to two 10 Gbps Small Form Factor Pluggable
(XFP) optical transceivers. XFPs are ordered separately and are available for short-reach and long-reach
applications. (See page 2-39
Important. The OS6800-XNI-U2 10 Gigabit expansion module cannot be hot swapped. Attempting to hot
swap the expansion module will result in a reboot of the switch and may interrupt network data flow.
XFP Status LEDs
The 10 Gigabit expansion module provides two LEDs (XFP1 and XFP2)
for monitoring XFP link status and activity. Each LED displays solid
green when its corresponding port is up; each LED blinks green when the
corresponding port is transmitting or receiving packets in a link up state.
The LEDs are off when no link is detected.
Note that OmniSwitch 6800-48, 6800-U24, and 6800-48-L switches
provide XFP status LEDs on the chassis front panel for easier visibility.
The function of chassis front panel LEDs is identical to the LEDs
included on the expansion module.
10 Gigabit Expansion Module Specifications
Number of ports
Power consumption
Data Speed
Transceiver Type Supported
Chassis port locations
page 2-34
OmniSwitch 6800 Series Chassis and Hardware Components
for more information on XFPs.)
XFP Ports
The OS6800-XNI-U2 module provides two ports for
10 Gbps Small Form Factor Pluggable (XFP) transceivers.
For additional information on XFPs, refer to
10 Gigabit Expansion Module Front Panel
OmniSwitch 6800 Series Hardware Users Guide
page 2-39.
2
16W (with two XFPs installed)
Approximately 10.3 Gbps (per port)
XFP
49 and 50 (OS6800-48, OS6800-48L);
25 and 26 (OS6800-U24)
July 2005